This seems to do the same thing since the “ routed” number decrements by one. What I noticed is that these can either be connected to each other where the rats nest is defined or if I connected to the blue line on the breadboard. There are numerous (GND) ground areas, are these to be connected directly to the negative (blue) power line on the breadboard.I am not sure where the power lines + /ground should be connected, the circuit wants 15VDC but I don’t see it in the schematic, I only see a symbol like ( + ) +15V, which I assume means connect this leg of the component to the positive power rail (red power line) on the breadboard - is this right?.The schematic doesn’t fit on one breadboard easily so I am trying to make it on two breadboards.Īs I am new to electronics I have several questions specific to Frizzing : I am building a TR-808 Kick clone from the schematics provided by the service notes and adapted by Eric Archer on his site.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |